Select and press S for the diametre.Display indication line 1: diametre Display indication line 2: circumference.

Select and press the first distance for the second distance for the third distance.Display indication line 4: triangle area. Display indication line 4: length of the slope, i.e. Display indication line 3: length of the hypotenuse. Display indication line 1: angle diagonal-horizontal. Select and press for the first distance for the second distance. Select and press for the first distance for the second distance for the third distance. In order to increase the measuring accuracy especially for long distances use a tripod. Display indication line 4: distance between both measuring points. Display indication line 3: distance to the second measuring point. for the first distance for the second distance Display indication line 1: angleĭisplay indication line 2: distance to the first measuring point. Hold the unit steady and imperatively wait until the self-calibration is completed. Display indication line 1: angle Display indication line 2: inclined distance top Display indication line 3: inclined distance bottom Display indication line 4: height. Select and press for the inclined distance top top point for the inclined distance botton. Display indication line 4: horizontal distance INDIRECT MEASUREMENT 2 Select and press Display indication line 1: angle.Display indication line 2: inclined distance top Display indication line 3: height. Use a tripod to increase the accuracy of the measurement. Here a general noteĪll measurements must be vertically in line without lateral deviation. on glass facades without measurement reflection or when the measurement object is obscured: Measure partial distances, missing distances are calculated by the device. Where direct measurements to the target are not possible, e.g. INDIRECT MEASUREMENTS VIA INCLINATION WITH HIGH ACCURACY Select and press the inclined distance top for the inclined distance bottom for the horizontal distance Display indication line 4: partial height. Select and press for the inclined distance top for the horizontal distance for the inclined distance bottom Display indication line 4 height. Display indication line 3 height PYTHAGORAS 3-POINT Select and press the inclined distance for the horizontal distance. Use a tripod to increase the measuring accuracy.All measurements must be vertically in line without lateral deviation.To do this, use the inclination indicator (0°).

When measuring the horizontal distance (2nd dimension), the measurement must be taken at a 90° angle to the measuring surface.Select and press V for the first distance for the second distanc for the third distance Display indication line 4 volume for a new volume calculation, press the OFF button to quit this mode. Select and press S for the first distance for the second distance Display indication line 3 area for a new area calculation, press the OFF button to quit this mode. Select the required menu item and confirm by a short press repeat the mode leave the mode.

Navigation within the following measuring modes Display indication: maximum, minimum and the last measured value. Press to stop the continuous measurement. Sweep slowly the unit back and forth over the selected target point. Power on the unit – measuring mode: single measurement For taking measurements press CONTINUOUS MEASUREMENT In the modes distance measurement, area and volume calculation slide left and select + or – to execute the requested task. Press to select the requested measuring reference. Press to activate the camera function in all measuring modes, in case the target is not visible with the eye -especially in case of outdoor measurement zoom in/out Start the measurement. The green L shows the parameter to be determined. In all measuring modes (except single and continuous measurement) the red line shows which parameter will be measured next. The integrated tilt sensor 360° is always active. The instrument automatically saves the last 1.000 measured values. Green bar move the bar exactly between the marks.Īfter 3 minutes without operation the instruments powers off auto-matically. Numerical slope indication: Preferably keep the instrument at 0°. In order to increase the measuring accuracy in horizontal direction the instrument offers a levelling support in the display DISPLAY INDICATION IN MEASURING MODE HORIZONTAL LEVELLING DISPLAY INDICATION m / ft / in / ft+in front, tripod, rear.Time-delayed measurement Quit the menu.Rotate the display -> available in measuring mode.The menu keys are operated with a finger tip. Coming from the start screen slide right selection of the measuring modes. The instrument is equipped with a touch screen.

Geodist 40